To replace a Half-Duplex to Full-Duplex Converter or remove it from service, follow
these steps:
-
Disconnect the half-duplex ports
(HD1 - HD4) from your half-duplex devices.
-
Disconnect the full-duplex ports
(FD1 - FD4) from the switch.
-
Disconnect the converter to its
power adapter.
-
Disconnect the power
adapter from its AC power source.
-
Disconnect the DC power
cable from the power adapter and from the DC input socket on the side of
the converter.
-
Remove the grounding
wire from the converter.
-
If the converter is attached to
a 3-slot modular shelf, loosen the cable ties and remove it from the
shelf.
-
Optionally, install a new
converter using the instructions in Installing a Half-Duplex to Full-Duplex Converter.