Installing an RPS-150XT in a Rack

To install the RPS-150XT in the three-slot modular shelf (STK-RPS-1005CH3), you must first install the shelf in a 19-inch rack.

Caution

Observe all ESD precautions when handling sensitive electronic equipment.

Caution

Before rack-mounting the device, ensure that the rack can support it without compromising stability. Otherwise, personal injury and/or equipment damage may result.

To install the RPS-150XT in a rack, follow these steps.

1. Secure the front of the three-slot modular shelf (STK-RPS-1005CH3) to the rack by screwing four rack screws into the mounting ears on the right and left front of the shelf.
   See Securing the Three-slot Modular Shelf to a Rack.

   

   Securing the Three-slot Modular Shelf to a Rack

   
2. Slide the power supply into an empty bay in the shelf.
   See Installing an RPS-150XT Power Supply Unit in a Shelf.

   

   Installing an RPS-150XT Power Supply Unit in a Shelf

   
3. Tighten the captive screws to secure the power supply to the shelf.
4. Connect the RPS-150XT to its power source.
   See Connecting the RPS Cable and AC Power Cord to an RPS-150XT.