Installing Your Extreme Networks Switch

Before you attempt to install or remove an Extreme Networks switch, read the precautions in Safety Considerations for Installing Switches.

If you are installing switches for use in a SummitStack configuration, read Building Stacks before you install the switches.

Note

For information about installing older Summit-branded switches, refer to ExtremeSwitching and Summit Switches: Hardware Installation Guide for Switches Using ExtremeXOS 16 or Earlier.

1. Prepare the site for installing the switch.
   See Pre-installation Requirements.
2. Install the switch in the rack.
   See Attaching the Switch to a Rack or Cabinet.
3. Install optional components: optical transceivers, port option cards, versatile interface modules (VIMs), and stacking modules.
   See the instructions in Installing Optional Components.
4. Install one or two power supplies (for switches that require them) and connect to an electrical source.
   See Installing Internal Power Supplies.

   

   Note

   Be aware of whether you are installing an AC-powered switch or a DC-powered switch. The installation instructions are different depending upon what type of power is used.
5. Connect power to the switch.
   See Connecting Power to the Switch.
6. For a stacked configuration, connect stacking cables.
   See Connecting the Switches to Form the Stack Ring.
7. Connect network interface cables.
   See Connecting Network Interface Cables.
8. Perform initial network connection and configuration.
   See Performing Initial Management Tasks.