L2TPV3 Tunnel

To define an L2TPV3 configuration for a profile:

1. Select Configuration > Profiles > Network.

2. Expand the Network menu to display its submenu options.

3. Expand the Network menu and select L2TPv3.

4. Select the L2TPv3 Tunnel tab.

   

5. Review the following L2TPv3 tunnel configuration data:

   Name	Displays the name of each listed L2TPv3 tunnel assigned upon creation.
   Local IP Address	Lists the IP address assigned as the local tunnel end point address, not the interface IP address. This IP is used as the tunnel source IP address. If this parameter is not specified, the source IP address is chosen automatically based on the tunnel peer IP address.
   MTU	Displays the maximum transmission unit (MTU) size for each listed tunnel. The MTU is the size (in bytes) of the largest protocol data unit that the layer can pass between tunnel peers.
   Use Tunnel Policy	Lists the L2TPv3 tunnel policy assigned to each listed tunnel.
   Local Hostname	Lists the tunnel specific hostname used by each listed tunnel. This is the host name advertised in tunnel establishment messages.
   Local Router ID	Specifies the router ID sent in the tunnel establishment messages.

6. Either select Add to create a new L2TPv3 tunnel configuration, Edit to modify an existing tunnel configuration or Delete to remove a tunnel from those available to this profile.