To enable Smart RF select and shutdown 2.4 GHz APs causing interefrence:
Enable |
Select to enable auto-shutdown of radios causing interference within the Smart RF monitored network. Auto-shutdown of select 2.4 GHz radios, in dual-band networks, maintains CCI levels within specified limits. When enabled, Smart-RF monitors CCI levels to ensure that the deployment average CCI remains within specified minimum and maximum limits. If the deployment average CCI is found to exceed the maximum threshold, 2.4 GHz radios, causing neighbor interference, are shut down one-by-one until the deployment average CCI falls below the specified maximum threshold. The reverse process occurs when the deployment average CCI falls below the minimum threshold. In this scenario, previously disabled radios are enabled until the deployment average CCI reaches acceptable levels. Note: This feature is enabled by
default.
|
CCI High Threshold | Specify the maximum CCI threshold
from -85 to -55 dBm. The default value is -80 dBm. Note: If not specified, the system uses
the default value as the upper limit for the deployment
average CCI range.
|
CCI Low Threshold | Specify the minimum CCI threshold
from -85 to -55 dBm. The default value is -100 dBm. Note: If not specified, the system uses
the default value as the lower limit for the deployment
average CCI range.
|
Frequency | Configure the interval, in
minutes, at which 2.4 GHz radios are selected for shut down.
when the deployment average CCI exceeds the specified
maximum threshold, Smart RF shuts down 2.4 GHz radios until
the CCI reaches acceptable levels. Use this option, to
configure the interval between successive radio shut down. Specify the frequency from 0 - 3600 minutes. The default is 60 minutes. |
Frequency Limiter | Configure the minimum multiple of
Interference Recovery frequency that the select-shutdown
frequency can be set to. Specify a value from 1 - 1000. The default value is 15. |