To enable Smart RF select and shutdown 2.4 GHz APs causing interference:
| Enable |
Select to enable auto-shutdown of radios causing interference within the Smart RF monitored network. Auto-shutdown of select 2.4 GHz radios, in dual-band networks, maintains CCI levels within specified limits. When enabled, Smart-RF monitors CCI levels to ensure that the deployment average CCI remains within specified minimum and maximum limits. If the deployment average CCI is found to exceed the maximum threshold, 2.4 GHz radios, causing neighbor interference, are shut down one-by-one until the deployment average CCI falls below the specified maximum threshold. The reverse process occurs when the deployment average CCI falls below the minimum threshold. In this scenario, previously disabled radios are enabled until the deployment average CCI reaches acceptable levels. Note: This feature is enabled by
default.
|
| CCI High Threshold | Specify the maximum CCI threshold
from -85 to -55 dBm. The default value
is -80 dBm. Note: If not specified, the system uses the
default value as the upper limit for the
deployment average CCI
range.
|
| CCI Low Threshold | Specify the minimum CCI threshold
from -85 to -55 dBm. The default value
is -100 dBm. Note: If not specified, the system uses the
default value as the lower limit for the
deployment average CCI
range.
|
| Frequency | Configure the interval, in minutes,
at which 2.4 GHz radios are selected for
shut down. when the deployment average
CCI exceeds the specified maximum
threshold, Smart RF shuts down 2.4 GHz
radios until the CCI reaches acceptable
levels. Use this option, to configure
the interval between successive radio
shut down. Specify the frequency from 0 - 3600 minutes. The default is 60 minutes. |
| Frequency Limiter | Configure the minimum multiple of
Interference Recovery frequency that the
select-shutdown frequency can be set
to. Specify a value from 1 - 1000. The default value is 15. |