Configuration Summary for BlackDiamond
X8 and 8800, SummitStack, and Summit Family Switches
Use the following procedure to configure QoS on BlackDiamond X8
and 8800 series switches, SummitStack, and Summit family switches:
-
Configure basic Layer 2 connectivity
(prerequisite).
-
Configure QoS scheduling, if needed, as described in Selecting the QoS Scheduling Method.
-
Configure ingress and egress rate-limiting as
needed:
-
Create a meter as described in Creating Meters.
-
Configure the meter as described in Configuring a Meter.
-
Apply the meter to ingress traffic as described in
Applying a Meter to Ingress or Egress Traffic.
-
Configure non-ACL-based egress QoS profile selection as
described in the following sections:
-
Configure 802.1p or DiffServ packet marking as described
in Configuring 802.1p or DSCP Replacement.
-
Configure egress QoS profile rate shaping as needed:
-
Create egress QoS profiles as described in Creating or Deleting an Egress QoS Profile.
-
Configure egress QoS profile rate shaping parameters
as described in Configuring an Egress QoS Profile.
-
Configure egress port rate shaping as described in Configuring Egress Port Rate Limits.
-
Finalize ACL traffic-based group configuration as
described in Configuring an ACL-Based Traffic Group.
-
Verify the configuration using the commands described in
Displaying QoS Configuration and Performance.