Remove all power cords from the power
supply switch. There should be no power to the switch.
Insert the FAT formatted USB memory drive into the bottom
USB port (labeled USB-1) of the MM installed in the slot you wish
to recover.
If present, remove the MM from the other management slot.
Place the MM in a safe location and do not reinstall it until you
finish recovering the switch.
Attach a rollover serial cable to the console port of
the MM still installed.
Attach the other end of the serial cable to a properly
configured terminal or terminal emulator.
The terminal settings are:
9600 baud
8 data bits
1 stop bit
no parityXON/OFF flow control enabled
Provide power to the switch by re-inserting the power
cords into the power supplies.
Immediately press the spacebar until the BootROM -> prompt
appears.