Clearing the Shutdown State
If you configure the switch to shut down upon detecting a hardware fault, and the
switch enters the shutdown state, you must explicitly clear the shutdown state and reboot for
the switch to become functional.
-
Clear the shutdown state with the command:
clear
sys-recovery-level On a SummitStack, use the
command:
clear sys-recovery-level slot slot
The switch prompts you to confirm this action. The following is a
sample confirmation message:
Are you sure you want to clear sys-recovery-level? (y/n)
-
Enter y to confirm this action and
clear the shutdown state. Enter n or press
[Enter] to cancel this action.
After you clear the shutdown state, use the
reboot command to bring the switch and ports back online. After rebooting,
the switch is operational.