Enabling and Disabling 802.1X Network Login
Network Login must be disabled on a port before you can delete a VLAN
that contains that port. You can set a reauthentication maximum counter value to indicate
the number of reauthentication trials after which the supplicant is denied access or given
limited access.
-
To enable 802.1X network login on the switch, use the
following command:
Any combination of types of authentication can be enabled on
the same switch. At least one of the authentication types must be
specified on the CLI.
-
To disable 802.1X network login on the switch, use the
following command:
-
To enable 802.1X network login on one or more ports, use
the following command:
-
To disable 802.1X network login on one or more ports, use
the following command:
-
To configure the reauthentication counter values, use the
following command:
-
To unconfigure the reauthentication counter values, use
the following command: