Configuring SyncE

A link flap occurs in the following scenarios:

Link is configured as clock source via the command configure network-clock sync-e clock-source source-1/source-2.
Link is unconfigured for clock source via the command:

unconfigure network-clock sync-e ports port.
When a valid input clock is selected via the port configured as clock source.
When a valid input clock becomes unavailable via the port configured as clock source.

To enable SyncE on ports, use the following command:
enable network-clock sync-e port [port_list | all]
To disable SyncE on ports, use the following command:
disable network-clock sync-e port [port_list | all]
To configure SyncE on ports, use the following command:
configure network-clock sync-e [source-1 | source-2] port port
To unconfigure SyncE on ports, use the following command:
unconfigure network-clock sync-e [port port]
To display the configuration and port state, use the following command:
show network-clock sync-e port [port_list] {details}
To display SyncE as part of the port configuration, use the following command:
show port {mgmt | port_list | tag tag} information {detail}
To configure the input network clock source, use the following command:
configure network-clock clock-source input {[sync-e | ptp | tdm | [bits-rj45 | bits-bnc] {quality-level value}] | region [E1 | T1]}
To configure the output network clock source, use the following command:
configure network-clock clock-source output {bits-bnc-1 [1pps | 8KHz] bits-bnc-2 [E1 | T1 | 10MHz]}
To display the configured network clock source information, use the following command:
show network-clock clock-source

Published March 2020prev | next