Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

Using Motion Detectors

On the Summit X670 switch, there is a motion detection system that controls whether the port LEDs are turned on or off. When the motion detector is enabled, the LEDs are turned on only when motion is detected. You can also configure the time in seconds that the LEDs stay on after motion is detected. When the motion detector is disabled, the LED are always turned on.

  1. To configure the motion detector, use the following command:
    configure power led motion-detector [disable | enable {timeout seconds}]
  2. To show the status and timeout setting of the motion detector, use the following command:
    show power led motion-detector
Published March 2020prev | next

Email this topicEmail this topic

Print this pagePrint this page