Configuring the Failsafe Account on a Stack
The failsafe account information is stored in each node's local NVRAM.
-
Change the failsafe account from the master node using the
following command:
configure
failsafe-account {[deny | permit] [all | control | serial | ssh {vr vr-name} | telnet {vr vr-name}]}
This command changes the account
information in the NVRAM of every active node in the same active topology.
-
If a new node is added later, use the following command to
copy the failsafe account information from the master to the new node:
synchronize stacking {node-address node_address | slot slot_number}