You can use the num variable to specify a maximum number of
shared paths. Or you can use the use-load-sharing keyword to use the
value that has already configured by means of the ip load-sharing
command.
-
Access global configuration
mode.
device# configure terminal
-
Access BGP configuration mode.
device(config)# router bgp
-
Access IPv4 address family
configuration mode.
device(config-bgp-router)# address-family ipv4 unicast
-
Perform one of the following
steps to specify load-sharing paths:
The following example summarizes the commands in
this procedure
device# configure terminal
device(config)# router bgp
device(config-bgp-router)# address-family ipv4 unicast
device(config-bgp-ipv4u)# maximum-paths 8
device(config-bgp-ipv4u)# maximum-paths use-load-sharing
