Using a route map to advertise a default route

The route-map “myroutemap” must already be configured.

Enter the configure terminal command to access global configuration mode.
```
device# configure terminal
```
Enter the router isis command to enter IS-IS router configuration mode and enable IS-IS on the device.
```
device(config)# router isis
```
Enter the address-family ipv6 unicast command to enable ISIS address-family IPv6 unicast configuration mode.
```
device(config-isis-router)# address-family ipv6 unicast
```
Enter the default-information-originate command with the route-map parameter and specify a route-map parameter to use the route map to enable the advertisement of a default route.
```
device(config-router-isis-ipv6u)# default-information-originate route-map myroutemap
```

The following example enables the advertisement of a default route if the route map “myroutemap” is satisfied for the IPv6 address family.

device# configure terminal
device(config)# router isis
device(config-isis-router)# address-family ipv6 unicast
device(config-router-isis-ipv6u)# default-information-originate route-map myroutemap