In the following task steps, network 10.1.1.0/24 is configured to be tracked, and if the network goes offline, the VRRP priority of the current master device is lowered by a value of 20.
-
Enable VRRP-E globally.
device(config)# protocol vrrp-extended
-
Enter interface configuration mode.
device(config)# interface ve 100
-
Run the following command to enter group configuration mode.
device(config-if-Ve-100)# vrrp-extended-group 1
-
Enter the
track network command to set the track network (route) and priority:
device(config-vrrp-group-1)# track network 10.1.1.0/24 priority 20
-
Return to privileged EXEC mode.
device(config-vrrp-group-1)# end
-
To view tracked networks with their priority and status, enter the following command:
device# show vrrp detail
Total number of VRRP session(s) : 1
VRID 3
Interface: Ve 100; Ifindex: 1207959652
Mode: VRRPE
.
.
.
Hold time: 0 sec (default: 0 sec)
Master Down interval: 4 sec
Trackport:
Port(s) Priority Port Status
======= ======== ===========
Tracknetwork:
Network(s) Priority Status
======= ======== ===========
10.1.1.0/24 20 Down
Global Statistics:
==================
Checksum Error : 0
Version Error : 0
VRID Invalid : 0
Session Statistics:
===================
Advertisements : Rx: 0, Tx: 0
Neighbor Advertisements : Tx: 0
.
.
.
The following example shows how to configure network 10.1.1.0/24 to be tracked. If the network goes down, the VRRP-E device priority is lowered by a value of 20. The lower priority may trigger a switchover and a backup device with a higher priority becomes the new master for VRRP-E group 1.
device(config)# protocol vrrp-extended
device(config)# interface ve 100
device(config-if-Ve-100)# vrrp-extended-group 1
device(config-vrrp-group-1)# track network 10.1.1.0/24 priority 20
