Multiple route reflectors should
belong to the same cluster. By default, the value for the cluster-id command is
the device ID. Use this procedure to change the device ID.
-
Access global configuration
mode.
device# configure terminal
-
Access BGP configuration mode.
device(config)# router bgp
-
Specify the autonomous system in which your device resides.
device(config-bgp-router)# local-as 1000
-
Change the device ID.
device(config-bgp-router)# cluster-id 321
This example changes the cluster ID of a device from the default value to
321.
The following example summarizes the commands in this
procedure.
device# configure terminal
device(config)# router bgp
device(config-bgp-router)# local-as 1000
device(config-bgp-router)# cluster-id 321
