-
Enter the
configure terminal command to access global configuration mode.
device# configure terminal
-
Enter the
ip router-id command to specify the router ID.
device(config)# ip router-id 10.11.12.13
-
Enter the
ipv6 router ospf command to enter OSPFv3 router configuration mode and enable OSPFv3 on the device.
device(config)# ipv6 router ospf
-
Enter the
key-add-remove-interval command and specify the desired interval to set the timing of the authentication key add-remove interval.
device(config-ipv6-router-ospf-vrf-default-vrf)# key-add-remove-interval 240
-
Enter the
key-rollover-interval command and specify the desired interval to set the timing of the configuration changeover.
device(config-ipv6-router-ospf-vrf-default-vrf)# key-rollover-interval 240
The following example sets the key add-remove interval to 240 seconds (4 minutes) and sets the timing of the configuration changeover to 240 seconds (4 minutes).
device# configure terminal
device(config)# ip router-id 10.11.12.13
device(config)# ipv6 router ospf
device(config-ipv6-router-ospf-vrf-default-vrf)# key-add-remove-interval 240
device(config-ipv6-router-ospf-vrf-default-vrf)# key-rollover-interval 240
