Configure BGP Flowspec Rules

1. From privileged EXEC mode, enter global configuration mode.
   

   device# configure terminal

2. Create a route map for BGP flowspec rules that allows a matching pattern.
   

   device(config)# route-map flowspec_map permit 56

   This example creates a route map named flowspec_map that allows a matching pattern and enters configuration mode for the route-map sequence number 56.

   

   Note

   Route-map deny sequences are not advertised as flowspec rules and deny configurations are ignored.
3. Configure matching based on destination prefix.
   

   device(config-route-map-flowspec_map/permit/56)# match ip destination-address 10.2.3.0/24

4. Configure matching based on protocol number.
   

   device(config-route-map-flowspec_map/permit/56)# match protocol eq 30

5. Configure matching based on a range of protocol numbers.
   

   device(config-route-map-flowspec_map/permit/56)# match protocol range 40 50

6. Configure matching based on traffic having all specified TCP flags.
   

   device(config-route-map-flowspec_map/permit/56)# match tcp-flags all not-fin ack

   In this example, because the all option is specified, a match occurs when traffic matches all of the specified options (not-fin and ack).
7. Configure matching based on traffic having any of the specified TCP flags.
   

   device(config-route-map-flowspec_map/permit/56)# match tcp-flags any cwr urg

   Because the any option is specified in this example, a match occurs when traffic matches any other specified option: cwr or urg.
8. Configure matching based on traffic having an ICMP type that is not equal to 5.
   

   device(config-route-map-flowspec_map/permit/56)# match ip icmp-type neq 5

9. Configure a committed information rate (CIR) action.
   

   device(config-route-map-flowspec_map/permit/56)# set police cir 0

10. Configure a mirroring destination.
    

    device(config-route-map-flowspec_map/permit/56)# set ip mirror 10.67.67.9

11. Return to privileged EXEC mode.
    

    device(config-route-map-flowspec_map/permit/56)# end

12. If you configured a route map for the first time, activate the BGP flowspec rules. For more information, see Distribute BGP Flowspec Rules.

The following example summarizes the commands in this task.

device# configure terminal
device(config)# route-map flowspec_map permit 56
device(config-route-map-flowspec_map/permit/56)# match ip destination-address 10.2.3.0/24
device(config-route-map-flowspec_map/permit/56)# match protocol eq 30
device(config-route-map-flowspec_map/permit/56)# match protocol range 40 50
device(config-route-map-flowspec_map/permit/56)# match tcp-flags all not-fin ack
device(config-route-map-flowspec_map/permit/56)# match tcp-flags any cwr urg
device(config-route-map-flowspec_map/permit/56)# match ip icmp-type neq 5
device(config-route-map-flowspec_map/permit/56)# set police cir 0
device(config-route-map-flowspec_map/permit/56)# set ip mirror 10.67.67.9