Configure BGP4 Route Map Matching on a Destination Network

1. Access global configuration mode.
   

   device# configure terminal

2. Create a route map instance and allow a matching pattern.
   

   device(config)# route-map mynetroutemap1 permit 10

   This example creates a route map instance named mynetroutemap1 and allows a matching pattern of 10.
3. Configure the route map to match on a specified prefix.
   

   device(config-route-map-mynetroutemap1/permit/10)# match ip address prefix-list mylist

   This example configures the route map to match on the prefix list titled mylist.

This example summarizes the commands in this procedure.

device# configure terminal
device(config)# route-map mynetroutemap1 permit 10
device(config-route-map-mynetroutemap1/permit/10)# match ip address prefix-list mylist