Configuring BGP4 Graceful Restart

Note

High availability (HA) requires GR to be enabled.

Enter the configure terminal command to access global configuration mode.
```
 device# configure terminal
```
Enter the router bgp command to enable BGP routing.
```
device(config)# router bgp
```
Enter the local-as command to configure the autonomous system number (ASN) in which your device resides.
```
 device(config-bgp-router)# local-as 1000
```
Enter the neighbor ip address remote-as command to add a neighbor.
```
 device(config-bgp-router)# neighbor 10.11.12.13 remote-as 2
```
Enter the address-family ipv4 unicast command to enter IPv4 address-family configuration mode.
```
 device(config-bgp-router)# address-family ipv4 unicast
```
Enter the graceful-restart command to enable the graceful restart feature.
```
 device(config-bgp-ipv4u)# graceful-restart
```
Do any of the following:
- Enter the graceful-restart command and use purge-time parameter to overwrite the default purge-time value.
```
device(config-bgp-ipv4u)# graceful-restart purge-time 300
```
- Enter the graceful-restart command and use restart-time parameter to overwrite the default restart-time advertised to graceful restart-capable neighbors.
```
device(config-bgp-ipv4u)# graceful-restart restart-time 180
```
- Enter the graceful-restart command and use stale-routes-time parameter to overwrite the default amount of time that a helper device will wait for an EOR message from a peer.
```
device(config-bgp-ipv4u)# graceful-restart stale-routes-time 100
```

The following example enables the GR feature.

device# configure terminal	
device(config)# router bgp
device(config-bgp-router)# local-as 1
device(config-bgp-router)# neighbor 10.11.12.13 remote-as 2
device(config-bgp-router)# address-family ipv4 unicast
device(config-bgp-ipv4u)# graceful-restart

The following example enables the GR feature and sets the purge time to 300 seconds, over-writing the default value.

device# configure terminal
device(config)# router bgp
device(config-bgp-router)# local-as 1
device(config-bgp-router)# neighbor 10.11.12.13 remote-as 2
device(config-bgp-router)# address-family ipv4 unicast
device(config-bgp-ipv4u)# graceful-restart purge-time 180

The following example enables the GR feature and sets the restart time to 180 seconds, over-writing the default value.

device# configure terminal
device(config)# router bgp
device(config-bgp-router)# local-as 1
device(config-bgp-router)# neighbor 10.11.12.13 remote-as 2
device(config-bgp-router)# address-family ipv4 unicast
device(config-bgp-ipv4u)# graceful-restart restart-time 180

The following example enables the GR feature and sets the stale-routes time to 100 seconds, over-writing the default value.

device# configure terminal
device(config)# router bgp
device(config-bgp-router)# local-as 1
device(config-bgp-router)# neighbor 10.11.12.13 remote-as 2
device(config-bgp-router)# address-family ipv4 unicast
device(config-bgp-ipv4u)# graceful-restart stale-routes-time 100

Use the clear ip bgp neighbor command with the all parameter for the changes to the GR parameters to take effect immediately.