Configure Unique Virtual MAC Addresses per VRID

On SLX-OS devices, you can configure a maximum of 13 virtual router MAC addresses per device; this includes both IPv4 VRRP-E & IPv6 VRRP-E sessions.

Note

System-assigned virtual MAC addresses and manually configured virtual MAC addresses can exist at the same time on the device under the same VRID, however the configured value takes precedence. When the configured value is deleted, the assigned value again applies.

Note

A virtual MAC address can be dynamically updated while a VRRP or VRRP-E session is enabled. When the VRRP or VRRP-E virtual MAC address is modified on the master device, expect a traffic drop until the host device receives the GARP request or Router Advertisement (RA) containing the updated virtual MAC address from the master VRRP device.

To configure a unique VRRP or VRRP-E virtual MAC address for a VRID, complete the following steps.

1. On the device designated as a VRRP-E device, from privileged EXEC mode, enter configuration mode.
   

   device# configure terminal
   

2. Globally enable the VRRP-E protocol.
   

   device(config)# protocol vrrp-extended
   

3. Configure a virtual ethernet interface link.
   

   device(config)# interface ve 10
   

4. Configure the IP address of the interface.
   All devices configured for the same VRID must be on the same subnet.
   

   device(config-if-Ve-10)# ip address 10.53.5.3/24
   

5. Assign the device to a VRID group.
   

   device(config-if-Ve-10)# vrrp-extended-group 12
   

   

   Note

   You can assign a VRID number in the range of 1 through 13. This example assigns the device to VRIP group 12.
6. Manually configure an IPv4 virtual MAC address for the virtual router group.
   

   device(config-vrrp-extended-group-12)# virtual-mac 02e0.5200.0012

   

   Note

   System-assigned virtual MAC addresses and manually configured virtual MAC addresses can exist at the same time on the device under the same VRID, however the configured value takes precedence. When the configured value is deleted, the assigned value again applies.
7. To display IPv4 VRRP-E virtual MAC address configuration information about VRID 12 (for example), enter the following command:
   

   device# show vrrp detail
   
   Total number of VRRP session(s)   : 1
   
   VRID 12
     Interface: Ve 10;  Ifindex: 1207959562
     Mode: VRRPE
     Admin Status: Enabled
     Description :
     Address family: IPv4
     Version: 2
     Authentication type: MD5 Authentication
     State: Initialize
     Session Master IP Address:
     Virtual IP(s): 192.168.4.100
     Virtual MAC Address: 02e0.5200.0112
   .
   .
   .

   The partial output shows the manually configured VMAC address.

The following example configures an IPv4 virtual MAC address for VRID 12 on a VRRP-E device.

device# configure terminal
device(config)# protocol vrrp-extended
device(config)# interface ve 10
device(config-if-Ve-10)# ip address 10.53.5.3/24
device(config-if-Ve-10)# vrrp-extended-group 12
device(config-vrrp-extended-group-12)# virtual-mac 02e0.5200.0012