Shows the remote end advertised ability.
| ports | Specifies ports. |
| port_list | Lists the ports that you want remote end advertised ability information on. |
| advertised | Selects showing auto-negotiation advertised capabilities. |
N/A.
Auto-negotiation is an Ethernet feature that facilitates the selection of port speed, duplex, and flow control between the two members of a link. It first shares these capabilities, and then selects the fastest transmission mode that both ends of the link can support.
This command shows the remote end of the link‘s advertised ability, up to 1Gbps speed only, for duplex and flow control. This command is not supported on Extended Edge Switching bridge port extenders (BPE) ports.
The following example shows the advertised ability for the remote end for ports 1 and 9:
# show port 1 9 advertised
10BaseT 100BaseT 100X 1000BaseT 1000X Pause
Port Half Full Half Full Half Full Half Full Half Full TX RX Asym
----- ---------- ---------- ---------- ---------- ---------- ------------
*1 CL- CL- CL- CL- --- --- --- --- --- --- CLR CLR ---
!9 CL- CL- CL- CL- --- --- --- --- --- --- C—- C-- ---
This command was first available in ExtremeXOS 30.2.
This command is available on the ExtremeSwitching X450-G2, X460-G2, X670-G2, X440-G2, X465, X590, X620, and X690 series switches.