Displays information about the individual events (conditions) that can be logged.
| event condition | Specifies the event condition to display. |
| all | Specifies that all events are to be displayed. |
| event component | Specifies that all the events associated with a particular component should be displayed. |
| severity | Specifies the minimum severity level of events to display (if the keyword only is omitted). |
| only | Specifies that only events of the specified severity level are to be displayed. |
| details | Specifies that detailed information, including the message format and parameter types, be displayed. |
If severity is not specified, then events of all severity are displayed. If detail is not specified, then summary only information is displayed.
This command displays the mnemonic, message format, severity, and parameter types defined for each condition in the event set specified.
See the command show log for more information about severity levels.
When the detail option is specified, the message format is displayed for the event conditions specified. The message format parameters are replaced by the value of the parameters when the message is generated.
To get a listing of the components present in the system, use the following command:
show log componentsThe following command displays the event conditions of severity debug-summary or greater in the component STP.InBPDU:
show log events stp.inbpdu severity debug-summary
The following is sample output from this command:
Comp SubComp Condition Severity Parameters ------- ----------- ----------------------- ------------- ---------- STP InBPDU Drop Error 2 total STP InBPDU Ign Debug-Summary 2 total STP InBPDU Mismatch Warning 2 total
The following command displays the details of the event condition PDUTrace in the component STP.InBPDU:
show log events stp.inbpdu.pdutrace details
The following is sample output from this command:
Comp SubComp Condition Severity Parameters ------- ----------- ----------------------- ------------- ---------- STP InBPDU Trace Debug-Verbose 2 total 0 - string 1 - string (printf) Port=%0%: %1%
This command was first available in ExtremeXOS 10.1.
This command is available on the ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, and X870 series switches.