This command, which should be used only in conjunction with a representative from Extreme Networks, clears the licensing information from the switch.
|
software |
Specifies ExtremeXOS base software license. |
| port-speed | Clears all port speed licenses (for ExtremeSwitching X870-96x-8c switches only). |
N/A.
Note
Use this command only under the guidance of an Extreme Networks representative.
When you issue the command, the following message is displayed:
This will clear the license information stored in EEPROM and also delete the license file (license.xlic). Are you sure you want to continue? (y/N)When you reply “yes”, the license information is removed from the EEPROM and the switch deletes the license.xlic file permanently.
Using the port-speed license keyword removes all port speed licensing. Port speed licenses increase the rate from 10G to 100G on QSFP28+ ports 1 through 24 on ExtremeSwitching X870-96x-8c switches.
The following command removes licensing information from the switch:
clear license-info
The following command removes port speed licensing from an ExtremeSwitching X870-96x-8c switch:
# clear license-info port-speed Are you sure you want to clear port speed license information stored in EEPROM? (y/N) Yes
This command was first available in ExtremeXOS 11.4.
The port-speed keyword was added in ExtremeXOS 22.2
This command is available on the ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, and X870 series switches.