This command globally enables or disables Convergence End Point (CEP) for ONEPolicy.
| enable | Enables CEP for ONEPolicy. |
| disable | Disables CEP for ONEPolicy. |
By default CEP is disabled.
This feature requires that ONEPolicy is enabled on the switch (see enable policy).
The following example enables CEP on the switch:
# configure policy convergence-endpoint enable
This command was first available in ExtremeXOS 22.2.
This command is available on the ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, and X870 series switches.