Use this command to display statistics (byte/packet counters) on a Virtual Network remote endpoint.
| vn_name | Display statistics only for the specified Virtual Network string. |
| ipaddress | IP address of the remote endpoint. |
| ipaddress | A remote endpoint IP address. |
| no-refresh | Page by page display without auto-refresh. |
VR-Default.
N.A.
To show statistics on an existing Virtual Network remote endpoint:
# show virtual-network remote-endpoint vxlan ipaddress 10.10.10.146 statistics VXLAN Statistics Tue Oct 13 13:40:32 2015 Virtual-Network Rx Total Rx Byte Tx Total Tx Byte Remote-endpoint Frames Count Frames Count ============================================================= 10.10.10.146 0 0 53496 0 ============================================================= 0->Clear Counters U->page up D->page down ESC->exit
# show virtual-network remote-endpoint vxlan statistics VXLAN Statistics Tue Oct 13 13:42:51 2015 Virtual-Network Rx Total Rx Byte Tx Total Tx Byte Remote-endpoint Frames Count Frames Count =========================================================== 10.10.10.146 0 0 53496 0 10.10.10.148 7870 928660 0 0 100.99.1.202 0 0 6917 816206 =========================================================== 0->Clear Counters U->page up D->page down ESC->exit
This command was first available in ExtremeXOS 21.1.
This command is supported on the ExtremeSwitching X670-G2, X465, X590, X690, X695, X870 series switches, and stacks with the same platforms.