configure port shared-packet-buffer

configure port port_list shared-packet-buffer [percent | default]

Description

Configures the maximum amount of the shared packet buffer to be used by the specified ports.


`port_list`	Specifies a list of ports or slots and ports.
`percent`	Specifies the maximum portion of the shared packet buffer to allot. The range is 0 to 100 percent.

Note

On some platforms, the hardware provides a limited number of settings. In these cases, ranges of percentage values achieve the same setting.

Note

You can view the configured percentage value using the show ports port-list info detail command.

Note

You can view the effect of this command using the show ports port-list buffer command.

None.

It is possible to overcommit the shared packet buffer using this command.

The following command sets the shared packet buffer for port 1:1 to 50%:

configure port 1:1 shared-packet-buffer 50

This command was first available in ExtremeXOS 12.5.

This command is available on the ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, and X870 series switches.