Configures the switch to flooding the unicast traffic during L2 protocol convergence.
| on | Used to avoid flooding the unicast traffic during L2 protocol convergence. (default) |
| off | Used to Temporarily flooding unicast traffic during L2 protocol convergence. |
On.
Use this command to influence the L2-protocol convergence when topology changes in the network to minimize the congestion.
The following command will influence the L2-Protocol control traffic:
configure forwarding L2-protocol fast-convergence off
This command was first available in ExtremeXOS 15.1.3.
This command is available on the ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, and X870 series switches.