VXLAN Layer 2 gateway considerations and limitations

Note the following considerations and limitations for VXLAN Layer 2 gateway.

The maximum number of tunnels supported are:
- 250 for SLX 9150/ SLX 9250
- 1024 for SLX 9540/ SLX 9640
A maximum of 64 ECMP paths are supported.
Layer 2 snooping is not supported.
VRRPe source IP addresses and Multi-Chassis Trunks (MCTs) are not supported.
QoS, TTL, and MTU values are not configurable. The MTU is based on the IP interface MTU. If a packet is bigger than the IP interface MTU minus the VXLAN header, the packet is dropped. The default TTL value is 255. The default QoS value is 0, which is applied to the DSCP field of the IP header.
VXLAN tunnels have the standard UDP header encapsulated with the standard defined value of 4789. This value is not configurable. SLX-OS expects VXLAN tunnel packets to be received with this value.
VXLAN tunnels are supported in the default profile.
VXLAN tunnels are not supported when the counter profile 1 or 4 is configured. These profiles do not allocate hardware resources for TX statistics, which is needed for VXLAN tunnels. (SLX 9540 and SLX 9640 only).
Static VXLAN Tunnels are not supported on the SLX 9150 and SLX 9250.
The tunnel TX bytes statistics do not account for the outer VLAN header size.
When BUM packets received on a tunnel are flooded, split horizon drops the packets to the same tunnel. However, the TX Statistics counter on that tunnel increments.

VNI Mapping

VLAN-VNI mapping is shared by all VxLAN tunnels including the ICL. There are three methods of configuring VNI mapping.

Auto-Mapping
- This is the default configuration, and is recommended for use with the cluster. The first 32K are reserved for the VNI range. A one-to-one mapping between the VLAN/BD and the VNI is configured.
Manual Mapping for a specific VLAN/BD (hybrid mode)
- With map vni auto configured, a specific VLAN/BD can be manually mapped. The manual mapping VNI range starts at 32768. Other VLANs/BDs will continue to use auto mapping.
Manual mapping of all VLANs/BDs (disable auto mapping)
- When auto mapping is disabled, manual VNI mapping is required for all VLANs/BDs created on the system (even the VLANs/BDs that are not configured under EVPN). In this mode, the complete VNI range (1-2^24) is available for manual mapping.
  Note
  - When the VNI mapping is changed, traffic on the ICL is impacted.
  - The VNI Mapping on the two nodes must match.