Configuring ERP

To configure and initialize ERP using only APS you must set up one RPL owner and one or more Non-RPL nodes. The minimum configuration tasks are listed in this section.

Before configuring ERP, however, you must have already configured a VLAN and ports.

Note

ERP supports topology-groups if the ERP interfaces are in the same VLAN

You must perform the following minimum configuration tasks for the RPL owner:

• Configure an ERP instance.
• Set the left and right interfaces.
• Set the role as owner.
• Set the RPL.
• Enable the configuration.

You must perform the following minimum configuration tasks for each non-RPL node:

• Configure an ERP instance.
• Set the left and right interfaces.
• Enable the configuration.