To refresh a specific network-zone, or all the network-zones, enter the following command:refresh access-list network-zone [zone_name | all]
Here is an example:
Switch# refresh access-list network-zone zone1
NoteWhen you issue the command to refresh a network-zone, or all network-zones, it can take a long time to clear the CLI because each individual policy must be converted before it is refreshed. The command succeeds, or fails, only after it receives a success response for all policy refresh, or when a first refresh failure is received from the hardware.
If the refresh fails for a specific zone, the following error message is printed on the console.
Switch# refresh access-list network-zone zone1 Error: Refresh failed for network-zone "zone1".