WLAN Mapping / Mesh Mapping

You can assign each WLAN its own BSSID. If using a single-radio access point, there are 8 BSSIDs available. If you are using a dual-radio access point there are 8 BSSIDs for the 802.11b/g/n radio and 8 BSSIDs for the 802.11a/n radio.

To set a radio's WLAN mapping configuration:

1. Select the WLAN Mapping tab.

   

   

2. Refer to the WLAN/BSS Mappings field to set WLAN BSSID assignments for an existing access point deployment.

   Use the ‘<‘ or ‘>‘ buttons to assign WLANs and mesh points to the available BSSIDs.

   You can assign each WLAN its own BSSID. If using a single-radio access point, there are 8 BSSIDs available. If using a dual-radio access point there are 8 BSSIDs for the 802.11b/g/n radio and 8 BSSIDs for the 802.11a/n radio. Each supported access point model can support up to 8 BSS IDs.

3. Select Advanced Mapping to enable WLAN mapping to a specific BSS ID.

4. Select OK to save the changes to the WLAN Mapping. Select Reset to revert to the last saved configuration.