About this task
Administrators can assign each WLAN
its own BSSID. If using a single-radio access point, there are 8 BSSIDs available. If using
a dual-radio access point there are 8 BSSIDs for the 802.11b/g/n radio and 8 BSSIDs for the
802.11a/n radio.
Note
WiNG 7.x.x does not
support MeshPoint configuration on AP3xx, AP4xx, and AP5xx model access points. This
feature will be supported in future releases.
To
set a radio's WLAN mapping configuration:
Procedure
-
Select the WLAN
Mapping tab.
-
Refer to the WLAN/BSS
Mappings field to set WLAN BSSID assignments for an existing access
point deployment.
Use the ‘<‘ or ‘>‘ buttons to
assign WLANs and mesh points to the available BSSIDs.
You can assign each WLAN its own BSSID. If using a single-radio access point,
there are 8 BSSIDs available. If using a dual-radio access point there are 8
BSSIDs for the 802.11b/g/n radio and 8 BSSIDs for the 802.11a/n radio. Each
supported access point model can support up to 8 BSS IDs.
-
Select Advanced Mapping
to enable WLAN mapping to a specific BSS ID.
-
Select OK to
save the changes.
Select Reset
to revert to the last saved configuration.
