| Channel Width |
Set the channel width the meshpoint‘s automatic channel
scan assigns to the selected radio. Available options
include:
- Automatic – The channel width is
calculated automatically. This is the default
value.
- 20
MHz – Sets the width between adjacent
channels as 20 MHz.
- 40
MHz – Sets the width between adjacent
channels as 40 MHz.
|
| Priority Meshpoint |
Configure the meshpoint monitored for automatic channel
scans. This is the meshpoint assigned priority over other
available mesh points. When configured, a mesh connection is
established with this mesh point. If not configured, a
meshpoint is automatically selected. |
| Off-channel Duration |
Set the duration (from 20 - 250 milliseconds) the scan
dwells on each channel when performing an off channel scan.
The default is 50 milliseconds. |
| Off-channel Scan Frequency |
Set the duration (from 1- 60 seconds) between two
consecutive off channel scans. The default is 6
seconds. |
| Meshpoint Root: Sample Count |
Configure the number of scan samples (from 1- 10) for
data collection before a mesh channel is selected. The
default is 5. |
| Meshpoint Root: Channel Hold Time |
Configure the duration (from 0 - 1440 minutes) to remain
on a channel before channel conditions are reassessed for a
possible channel change. Set this value to zero (0) to
prevent an automatic channel selection from occurring. The
default setting is 30 minutes. |
