session
Configures an LDP session for the neighbor-based filtering of inbound or outbound FECs, You can also configure an authentication key for the LDP session.
Syntax
session
remote-ip-addr
{
filter-fec-in
|
filter-fec-outprefix-list
}
|
{
key
string
}
no session
remote-ip-addr
{
filter-fec-in
|
filter-fec-out
}
|
{
key
}
Parameters
- remote-ip-addr
- Specifies the IP address of the LDP peer.
-
filter-fec-in
- Applies neighbor-based LDP FEC filtering on inbound FECs.
-
filter-fec-out
- Applies neighbor-based LDP FEC filtering on outbound FECs.
- prefix-list
- Specifies the prefix list for the neighbor to which the filter is applied to allow or prevent the advertisement of FECs.
- key
string
- Configures an authentication key on the LDP session. The LDP session can be to an adjacent peer (basic discovery) or to the targeted peer (extended discovery).The string variable specifies a text string of up to 80 characters used for authentication between LDP peers. It must be configured on both peers.
Modes
MPLS LDP configuration mode
Usage Guidelines
Use the
no form of the command to remove the neighbor-based FEC filtering or authentication key from the LDP session.
MPLS is supported on the Extreme 8820, SLX 9740, SLX 9640, and SLX 9540 devices only.
Examples
The following example configures LDP to
prevent the advertisement of FEC 10.40.40.0/24 through the list-out prefix list and
allow all others FECs to neighbor 10.12.12.12.
device# configure terminal
device(config)# ip prefix-list list-out deny 10.40.40.0/24
device(config)# ip prefix-list list-out permit 0.0.0.0/0 ge 32
device(config)# router mpls
device(config-router-mpls)# ldp
device(config-router-mpls-ldp)# session 10.12.12.12 filter-fec-out list-out
