threshold-monitor bfd-sessions

Configures monitoring of the number of BFD Session against the maximum number of supported BFD sessions and alerts the user when configured thresholds are exceeded.

Syntax

threshold-monitor bfd-sessions [ high-limit value-in-percent ] [ low-limit value-in-percent ] [ actions [ none | raslog | snmp | all ] ]

no threshold-monitor bfd-sessions

Parameters

actions [ none | raslog | snmp | all ]

Specifies the action to be taken when a threshold is exceeded. The values supported are all, none, raslog, and snmp. Default is all.

all: RASLOG and SNMP trap will be sent when the threshold is exceeded.
none: No action will be taken when the threshold is exceeded.
raslog: Only RASLOG will be sent when the threshold is exceeded.
snmp: Only SNMP traps will be sent when the threshold is exceeded.

high-limit value-in-percentage

Specifies the upper threshold limit of BFD sessions as a percentage (%) that will trigger the configured action. The range is 10%-100%. The default value is 90%.

low-limit value-in-percentage

Specifies the lower threshold limit of BFD sessions as a percentage (%) that will trigger the configured action. The range is 10%-99%. The default value is 70%.

Modes

Global configuration mode

Usage Guidelines

The no form of this command will reset the values to default.

The low-limit threshold value cannot be equal to or higher than the value configured for the high-limit threshold value.

Examples

The following example configures the lower and higher threshold monitoring values for the BFD sessions.

SLX# configure terminal
SLX (config)# threshold-monitor bfd high-limit 95 low-limit 50 action all
SLX (config)#

The following example resets the configured BFD session threshold monitoring values to their defaults.

SLX# configure terminal
SLX (config)# no threshold-monitor bfd high-limit
SLX (config)# no threshold-monitor bfd low-limit
SLX (config)# no threshold-monitor bfd action