Disables the inheritance of an additional-paths capability (from the address family or peer group level) for a specific peer or peer group in a Border Gateway Protocol ( BGP) address family.
By default, an additional-paths capability configured for a specific BGP address family applies to all peer groups and peers configured under the address family, and an additional-paths capability configured for a peer group applies to all peers within the group.
BGP configuration mode
When the capability to send and receive additional-paths is configured at the address family or peer group level, the capability applies to all neighbors configured under the address family or within the peer group: you can use the neighbor additional-paths disable command to disable this capability inheritance for an individual peer or peer-group.
The no form of the command restores the default configuration.
The following example shows how to disable additional-paths capability inheritance (from the address-family configuration) for an IPv4 address-family peer (10.123.123.1).
device# configure terminal device(config)# router bgp device(config-bgp)# address-family ipv4 unicast device(config-bgp)# neighbor 10.123.123.1 additional-paths disable
The following example shows how to restore additional-paths capability inheritance (from the address-family configuration) for an IPv4 peer (10.123.123.1).
device# configure terminal device(config)# router bgp device(config-bgp)# address-family ipv4 unicast device(config-bgp)# no neighbor 10.123.123.1 additional-paths disable
The following example shows how to disable additional-paths capability inheritance (from the address- family configuration) for an IPv6 address-family peer with IP address 10.123.123.1.
device# configure terminal device(config)# router bgp device(config-bgp)# address-family ipv6 unicast device(config-bgp-ipv6u)# neighbor 10.123.123.1 additional-paths disable