The command is used to assign local LACP System ID. The same System ID should be used by both peers on the EVPN Multi-homing nodes.
There are no defaults for this command.
Ethernet Segment mode. Allowed only under port-channel interface.
This command is used to assign local LACP System ID. The same local port-channel id should be used by the peers (on EVPN Multi-homing nodes).
The no function removes the local ethernet segment identifier.
The following example enables the Ethernet Segment mode which is allowed only under port-channel interface.
SLX(config)# interface port-channel 1
SLX(config-Port-channel-1)# ethernet-segment
SLX(config-Port-channel-1-es)# lacp system-id 0011.2233.4455