Enables sFlow. sFlow can be configured globally or on an interface.
sFlow is disabled on the system.
Global Configuration Mode, Interface Mode
The no form of this command disables sFlow. When this command is run on an interface, it disables sFlow on that interface.
The following example configures sFlow globally.
SLX# configure terminal SLX (config)# sflow enable 2023/01/10-05:58:04.702198 , [SFLO-1001], 5826, DCE, INFO, GESpine2, sFlow is enabled globally. SLX (config)#
The following example configures sFlow on an interface.
SLX# configure terminal
SLX (config)# interface ethernet 0/25:2
SLX (conf-if-eth-0/25:2)# sflow enable
2023/01/10-07:08:03.093271 , [SFLO-1002], 5830, DCE, INFO, GESpine2, sFlow is enabled
for interface Ethernet 0/25:2.
SLX (conf-if-eth-0/25:2)#