Configures a bootstrap router (BSR) as a candidate to distribute rendezvous point (RP) information to the other PIM-SM (Sparse Mode) devices in a PIM-SM domain.
By default, the PIM router is not part of the BSR election process.
PIM Router configuration mode
Each PIM-SM domain has one active BSR. For redundancy, you can configure ports on multiple devices as candidate BSRs. PIM-SM uses an election process to select one of the candidate BSRs as the BSR for the domain. The BSR with the highest BSR priority is elected. If the priorities result in a tie, the candidate BSR interface with the highest IP address is elected.
Although you can configure the device as only a candidate BSR or an RP, a best practice is to configure the same interface on the same device as both a BSR and an RP.
The no bsr-candidate form of this command makes the PIM router cease to act as a candidate BSR.
device(config)# router pim device(config-pim-router)# bsr-candidate ethernet 2/2 30 255The following example configures a loopback interface as a candidate BSR.
device(config)# router pim device(config-pim-router)# bsr-candidate interface loopback 11 mask 32The following example configures a virtual interface as a candidate BSR.
device(config)# router pim device(config-pim-router)# bsr-candidate ve 120 30 250