Enables the end-of-lib configuration mode.
MPLS LDP configuration mode
Use the no form of this command to remove this mode and attribute under it.
The end-of-lib mode contains all the attributes of the end of lib capability and notification. Also, when you enable the end-of-lib mode, you can determine whether the two RFCs 5561 and 5919 are enabled by the LSR.
MPLS is supported on the Extreme 8820, SLX 9740, SLX 9640, and SLX 9540 devices only.
The following example enables the end-of-lib configuration mode.
device(config)# router mpls device(config-router-mpls)# ldp device(config-router-mpls-ldp)# eol device(config-router-mpls-ldp-eol)#