threshold-monitor lif

Configures monitoring of the number of LIFs against the maximum number of supported LIFs and alerts the user when configured thresholds are exceeded.

Syntax

threshold-monitor lif [ high-limit value-in-percent ] [ low-limit value-in-percent ] [ action [ none | raslog | snmp | all ] ]

no threshold-monitor lif [ high-limit | low-limit | action ]

Parameters

high-limit value-in-percentage

Specifies the upper threshold limit for number of LIFs as a percentage (%) that will trigger the configured action. The range is 10%-100%. The default value is 90%.

low-limit value-in-percentage

Specifies the lower threshold limit for number of LIFs as a percentage (%) that will trigger the configured action. The range is 10%-99%. The default value is 70%.

action [ none | raslog | snmp | all ]

Specifies the action to be taken when a threshold is exceeded. The values supported are all, none, raslog, and snmp. Default is all.

all: RASLOG and SNMP trap will be sent when the threshold is exceeded.
none: No action will be taken when the threshold is exceeded.
raslog: Only RASLOG will be sent when the threshold is exceeded.
snmp: Only SNMP traps will be sent when the threshold is exceeded.

Modes

Global configuration mode

Usage Guidelines

The no form of this command will reset the values to default.

The low-limit threshold value cannot be equal to or higher than the value configured for the high-limit threshold value.

Examples

The following example configures the lower and higher threshold monitoring values for the number of LIFs.

SLX# configure terminal
SLX (config)# threshold-monitor lif high-limit 95 low-limit 50 action all
SLX (config)#

The following example resets the configured LIFs threshold monitoring values to their defaults.

SLX# configure terminal
SLX (config)# no threshold-monitor lif high-limit
SLX (config)# no threshold-monitor lif low-limit
SLX (config)# no threshold-monitor lif action