This command displays the enable status of all supported Convergence End Point (CEP) types by port.
| port_list | Shows enable status for the listed ports. |
| all | Shows enable status for all ports. |
N/A
The following example shows the CEP enable status for port 3:
# show policy convergence-endpoint ports 3
Port Cisco LLDP-MED ---------- -------- -------- 3 enabled disabled
This command was first available in ExtremeXOS 22.2.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X690, and X695 series switches.