configure network-clock ptp ordinary add

configure network-clock ptp ordinary add {vlan} vlan_name {one-step | two-step} slave-only

Description

Add a VLAN to a PTP ordinary clock instance as a clock port.

Syntax Description


ordinary	Ordinary clock instance.
`vlan_name`	Name of the specific VLAN to be added to or deleted from the PTP clock instance.
one-step	1-step protocol mode (default).
two-step	2-step protocol mode.
slave-only	Force clock port to be a slave.

Default

The default protocol mode on the clock port is one-step.

Usage Guidelines

Use this command to add a VLAN to a PTP ordinary clock instance as a clock port. The ordinary clock master (grand-master) mode of operation is not supported.

The following restrictions apply on the VLAN to be added as clock port:

The VLAN should be tagged.
Loopback-mode should be enabled on the VLAN.
IPv4 address should be configured and IP forwarding must be enabled on the VLAN.
The VLAN should not have front panel ports added.

Example

The following example adds a vlan 'lpbk-gm' as a slave clock port to ordinary clock:

# configure network-clock ptp ordinary add vlan lpbk-gm one-step slave-only

The following example adds a vlan 'lpbk-gm2' as a slave clock port to ordinary clock in two-step mode:

# configure network-clock ptp ordinary add vlan lpbk-gm2 two-step slave-only

History

This command was first available in ExtremeXOS 15.1, but was not shown in the documentation until revision 2 of this guide.

Platform Availability

This command is available on the ExtremeSwitching X460-G2 platform.

Note

PTP commands can be used only with the Network Timing feature pack.