Configures the TACACS+ server.
tacas | Configures the TACACS+ server. |
tacas-accounting | Configure TACACS+ accounting server. |
primary | Configures the primary TACACS+ accounting server. |
secondary | Configures the secondary TACACS+ accounting server. |
host_ipaddress | The IP address of the TACACS+ accounting server being configured. |
host_ipv6address | The IPv6 address of the TACACS+ accounting server being configured. |
hostname | The host name of the TACACS+ accounting server being configured. |
tcp_port | The TCP port to use to contact the TACACS+ server. |
client_ipaddress | The client IP address used by the switch to identify itself when communicating with the TACACS+ accounting server. |
client_ipv6address | The client IPv6 address used by the switch to identify itself when communicating with the TACACS+ accounting server. |
vr_name | Specifies the virtual router
on which the client IP is located. Note: User-created VRs are
supported only on the platforms listed for this feature in the
ExtremeXOS 32.6.1 Feature License
Requirements
document.
|
Unconfigured. The default virtual router is VR-Mgmt, the management virtual router.
You can use the same TACACS+ server for accounting and authentication.
To remove a server, use the following command:
unconfigure tacacs server [primary | secondary]
The following command configures server tacacs1 as the primary TACACS+ accounting server for client switch 10.10.20.35 using a virtual router interface of VR-Default:
configure tacacs-accounting primary server tacacs1 client-ip 10.10.20.35 vr vr-Default
The following command configures IPv6 server 1111::220 as the primary TACACS+ server for client switch 1111::170 using virtual router interface of vr-mgmt:
# configure tacacs primary server 1111::220 client-ip 1111::170 vr vr-mgmt
This command was first available in ExtremeXOS 10.1.
IPv6 support was added in ExtremeXOS 32.6.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X690, and X695 series switches.