configure pim timer vlan

configure pim {ipv4 | ipv6} timer hello_interval jp_interval [{vlan} vlan_name | vlan all]

Description

Configures the global PIM timers on the specified router interfaces.

Syntax Description


ipv4	Specifies the IPv4 address family.
ipv6	Specifies the IPv6 address family.
`hello_interval`	Specifies the amount of time before a hello message is sent out by the PIM router. The range is 1–65,535 seconds.
`jp_interval`	Specifies the join/prune interval. The range is 1–65,535 seconds.
`vlan_name`	Specifies a VLAN name.
all	Specifies all VLANs.

Default

hello_interval—30 seconds
jp_interval—60 seconds

Usage Guidelines

These default timers should only be adjusted when excess PIM control packets are observed on the interface.

Example

The following example configures the PIM timers on the VLAN accounting:

configure pim timer 150 300 vlan accounting

History

This command was first available in ExtremeXOS 10.1.

Platform Availability

This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the PIM feature, see the ExtremeXOS 32.6.1 Feature License Requirements document.