Configures the source interface for a peer group and all the neighbors of the peer group.
| peer-group-name | Specifies a peer group. |
| any | Specifies any source interface. |
| ipAddr | Specifies an interface. |
N/A.
The source interface IP address must be a valid IP address of a VLAN configured on the switch.
Changes made to the parameters of a peer group are applied to all neighbors in the peer group.
This command applies to the current VR or VRF context.
After you enter this command, the switch automatically disables and enables the neighbors so that the changes can take effect.
The following command configures the source interface for the peer group outer and its neighbors on 10.34.25.10:
configure bgp peer-group outer source-interface ipaddress 10.34.25.10
This command was first available in ExtremeXOS 10.1.
This command required a specific license in ExtremeXOS 11.1.
This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the BGP feature, see the ExtremeXOS 32.6.1 Feature License Requirements document.