Displays the L2PT configuration and status of a service.
| vlan | Displays VLAN configuration. |
| vman | Displays VMAN configuration. |
| vlan_name | Specifies a VLAN name. |
| ports port_list | Displays the ports and port list separated by a comma ( , ) or dash ( - ). |
| detail | Displays the L2PT configuration and status in detail. |
Disabled.
Use this command to display the L2PT configuration and status of a service.
The following is an example of the show vman ports l2pt command:
# show vman cust2 ports 1:2,1:7 l2pt Interface L2PT Profile Name --------------- -------------------------------- 1:2 my_l2pt_prof 1:7 (none)
The following example illustrates the show vman l2pt ports detail command:
show l2vpn vpls cust1 l2pt
Interface L2PT Profile Name
--------------- --------------------------------
123.112.111.111 my_other_l2pt_prof
# show vman cust2 ports 1:2,1:7 l2pt
Interface L2PT Profile Name
--------------- --------------------------------
1:2 my_l2pt_prof
1:7 (none)
# show vman cust2 ports 1:2,1:7 l2pt detail
Port 1:2
L2PT Profile Name : my_l2pt_profile
Protocol Filter Name : filter1
Destination Address: 01:80:C2:00:00:02
Protocol Id Type : etype
Protocol Id Value : 0x8902
Field Offset : 14
Field Value : 03
Field Mask : FF
Action : Tunnel
CoS : Default
DSCP : 50
DSCP Replace : Yes
Packets Transmitted: 2300
Packets Received : 2300
Protocol Filter Name : filter2
Destination Address: 01:80:C2:00:00:00
Protocol Id Type : snap
Protocol Id Value : 0x4041
Field Offset :
Field Value :
Field Mask :
Action : Tunnel
CoS : 7
DSCP : 50
DSCP Replace : Yes
Packets Transmitted: 500
Packets Received : 500
Port 1:7
L2PT Profile Name : (none)
This command was first available in ExtremeXOS 15.5.
Support for DSCP was introduced in ExtremeXOS 31.3.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X690, and X695 series switches.