Configures an egress traffic rate limit for a port or groups of ports.
| port_list | Specifies one or more ports or slots and ports. |
| no-limit | Specifies traffic be transmitted without limit; use to reconfigure or unconfigure previous rate-limiting parameters. |
| cir-rate | Specifies the desired rate limit in Kbps, Mbps, or Gbps. |
| max-burst-size | Specifies the maximum burst size or peak burst size in kilobits (Kb) or megabits (Mb). |
No-limit.
1 Gbps port—64 Kbps increments.
10 Gbps port—1 Mbps increments.
If the specified egress limit (cir-rate) is not a multiple of 64 Kbps for a 1 Gbps port or 1 Mbps for a 10Gbps port, the specified value is rounded down to the nearest appropriate multiple based on the port type.
Unconfigure egress rate limiting on the port(s).
Reconfigure existing egress rate limiting on the port(s).
The max-burst-size parameter is the amount of traffic above the value in the cir-rate parameter that is allowed to burst from the port(s) for a short duration. If max-burst-size has been configured as "0", then it will use maximum available burst value.
configure port 1 rate-limit egress 3 Mbps max-burst-size 5 Mb
This command was available in ExtremeXOS 11.1.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X690, and X695 series switches.